About NIC1 (eth0) port usage on the appliance nodes — Access Appliances 8.6

Welcome to Cohesity Documentation.

Ask me anything. From setup and configuration to troubleshooting, architecture, features, and release updates, I'm here to help.

AI may make mistakes. Always verify critical information.

COHESITY Documentation

Explore our documentation to get started, discover products & new features, access troubleshooting guides, register sources, platforms support.

Products

Data Security Alliance

COHESITY Documentation

Explore our documentation to get started, discover products & new features, access troubleshooting guides, register sources, platforms support.

Products

Data Security Alliance

About NIC1 (eth0) port usage on the appliance nodes — Access Appliances 8.6 | Cohesity Documentation

Home

Access Appliances

NetBackup™ Access Appliance 8.6 Initial Configuration Guide

Network connection management

Configuring network address settings on the appliance nodes

About NIC1 (eth0) port usage on the appliance nodes

By default, NIC1 (eth0) is set to IP address 192.168.229.233. This private network address is reserved to provide a direct connection from a laptop to perform the initial configuration of the IPMI interface. The eth0 IP address cannot be changed. The eth0 is only used for the initial configuration of the IPMI interface or in situations where eth1 and IPMI are not reachable.

Feedback

Was this page helpful?

Deleting network settings on appliance nodes

About IPv4-IPv6-based network support on the Access Appliance

Feedback

Was this page helpful?