To use the traceroute command

• To use the Support> traceroute command, enter the following:

  Support> traceroute destination [source] 
  [maxttl]

  destination	The target node. To display all of the intermediate nodes that are located between two nodes on a network, enter the destination node. You need to specify either an IPv4 address for an IPv4 installation or an IPv6 address for an IPv6 installation. The accepted range for an IPv6 prefix is 0-128 integers.
  source	Specifies the source node name from where you want to begin the trace.
  maxttl	Specifies the maximum number of hops. The default is seven hops.

  For example, to trace the route to the network host, enter the following:

  Support> traceroute www.veritas.com fssClus_01 10
  traceroute to www.veritas.com (23.5.150.79), 10 hops max, 60 byte packets
   1  puna-sli-core-b01-vlan329.net.symantec.com (10.209.192.2) 0.356 ms  0.354 ms 0.376 ms
   2  punb-vfpi-eng-1-aggregate2-104.net.veritas.com (10.209.186.14) 0.298 ms 0.322 ms 0.379 ms
   3  puna-spi-core-b02-vlan105.net.symantec.com (143.127.185.130) 1.851 ms  1.964 ms  1.940 ms
   4  bnrcatcore01-teng6-2.net.symantec.com (143.127.185.205)  1.902 ms 1.903 ms 1.932 ms
   5  puna-vfpi-main-1-vip.net.veritas.com (10.212.252.50) 1.886 ms 1.945 ms 1.922 ms