Setting up SSO with NetBackup for NDMP
This topic describes the steps for setting up access to a drive that is shared between NDMP and NetBackup servers.
For a more complete discussion of SSO, refer to the NetBackup Administrator's Guide, Volume II.
This procedure assumes that the following conditions are true:
The prerequisites for SSO have been met, as described in the NetBackup Administrator's Guide, Volume II.
All physical devices, including the NDMP host, are correctly connected to the network.
NetBackup for NDMP supports the NDMP host.
See About NAS appliances support. for information about supported NDMP operating systems and NAS vendors. The topic also contains configuration and troubleshooting help for particular NAS systems.
The NetBackup Compatibility List for all Versions indicates which versions of vendor software support SSO for NDMP. The NAS systems (hardware) do not provide the support; the proper software version provides it. For a list of the features and software releases for each NAS vendor, for SSO support, and for the NetBackup versions that support these vendors, refer to the NetBackup Compatibility List for all Versions.
To set up an SSO with NetBackup for NDMP
- Configure NetBackup access to the NDMP host.
- Verify that the NDMP host can access the required robots and drives.
To verify NDMP host access to the required devices, run the following commands on a NetBackup media server that is authorized to access the host:
tpautoconf -verify ndmp_host_name tpautoconf -probe ndmp_host_name
The -verify option verifies that the NetBackup server can access the NDMP host. The -probe option lists the devices that are visible to the NDMP host.
- Use web UI to configure the devices and storage units.
You must define an NDMP storage unit for each NDMP host that shares a drive. If all hosts have access to the shared drive(s), web UI can create these storage units automatically.
More Information