About configuring media name and attribute rules
NetBackup uses the default settings and rules to name and assign attributes to new removeable media. NetBackup uses these rules when you do the following:
Add new media.
To add new media, run the Configure drives and robots wizard. On the left select . Then select .
Inventory a robot.
To inventory a robot, on the left select . Then select the Robots tab. Select the robot, then select . If NetBackup discovers new media in the robot, it adds that media to NetBackup.
For most configurations, the default settings work well. However, you can change the default settings and rules that NetBackup uses. Change the settings only if you have special hardware or usage requirements. You can change the settings from the or in the Inventory robot settings.
The following table shows the rules that you can configure:
Table: Attributes for media
| What | Where |
|---|---|
|
Media settings | |
|
Barcode rules |
See About barcodes. |
|
Media ID generation rules | |
|
Map media for API robots |