• External Certificate Authority (ECA) is supported Web UI only (port 443).

  For more information on how to configure ECA for Web UI port 443, refer to the following section:

• In case of load balancer service updating the CR with dynamic IP address to static IP address and vice versa is not allowed.

• Media server pods as NetBackup storage targets are not supported. For example, NetBackup storage targets like AdvancedDisk and so on are not supported on the media server pods.

• NetBackup Access Control (NBAC) and Enhanced Auditing (EA) configuration are not supported.

• Changes to the CorePattern which specifies the path used for storing core dump files in case of a crash are not supported. CorePattern can only be set during initial deployment.

AKS-specific

• As per Microsoft, since the NFS file share is in Premium account, the minimum file share size is 100GB. If you create a PVC with a small storage size, the following error message is displayed:

  "failed to create file share ... size (5)...".

• The IP displayed is of POD IP. NetBackup installing on container takes the IP address of POD as configured IP. Even logs would have POD IP reference at many places.

• (Applicable only for media servers) A storage class that has the storage type as Azure file is not supported. When the Config-Checker runs the validation for checking the storage type, the Config-Checker job fails if it detects the storage type as Azure file. But if the Config-Checker is skipped then this validation is not run, and there can be issues in the deployment. There is no workaround available for this limitation. You must clean up the PVCs and CRs and reapply the CRs.

• Only NFS is supported as the protocol while performing data migration with Azure premium files.

EKS-specific

• (Applicable only for media servers) A storage class that has the storage type as EFS is not supported. When the Config-Checker runs the validation for checking the storage type, the Config-Checker job fails if it detects the storage type as EFS. But if the Config-Checker is skipped then this validation is not run, and there can be issues in the deployment. There is no workaround available for this limitation. You must clean up the PVCs and CRs and reapply the CRs.