Set the debug level on a DB2 client (Windows)
To control the amount of information that is written to the debug logs, change the Database debug level. Typically, the default value of 0 is sufficient. However, technical support may ask you to set the value higher to analyze a problem.
The debug logs are located in install_path\NetBackup\logs.
Note:
Information from both the Verbose and the Database debug settings is logged to the same file, mmddyy.log.
To set the debug level
- Open the Backup, Archive, and Restore interface.
- Select File > NetBackup Client Properties.
- Click the Troubleshooting tab.
- Set the General debug level.
- Set the Verbose debug level.
Set this level to adjust the amount of information from the user exit program.
- Set the Database debug level.
Set this level to adjust the amount of information from the NBDB2 vendor library.
- Click OK to save your changes.