About installing patches and packages into Solaris SRTs — NetBackup 11.2.0.1

Welcome to Cohesity Documentation.

Ask me anything. From setup and configuration to troubleshooting, architecture, features, and release updates, I'm here to help.

AI may make mistakes. Always verify critical information.

COHESITY Documentation

Explore our documentation to get started, discover products & new features, access troubleshooting guides, register sources, platforms support.

Products

Data Security Alliance

COHESITY Documentation

Explore our documentation to get started, discover products & new features, access troubleshooting guides, register sources, platforms support.

Products

Data Security Alliance

About installing patches and packages into Solaris SRTs — NetBackup 11.2.0.1 | Cohesity Documentation

Home

NetBackup

NetBackup™ Bare Metal Restore Administrator's Guide

Shared resource trees

Managing shared resource trees

Adding software to a shared resource tree

Adding software to a UNIX or Linux SRT

About installing patches and packages into Solaris SRTs

Always use the bmrsrtadm command to install patches and packages into Solaris SRTs. The bmrsrtadm command prevents any damage from the packages that do not support the pkgadd -R flag.

Patches that are installed into the miniroot that do not support the patchadd -C flag can damage BMR boot servers as well as JumpStart servers. Therefore, do not install the patches into an SRT that do not support the patchadd -C flag.

Feedback

Was this page helpful?

About adding other software

Installing device drivers into Linux SRTs

Feedback

Was this page helpful?