About performing a full backup after a restore — NetBackup 11.2.0.1

Welcome to Cohesity Documentation.

Ask me anything. From setup and configuration to troubleshooting, architecture, features, and release updates, I'm here to help.

AI may make mistakes. Always verify critical information.

COHESITY Documentation

Explore our documentation to get started, discover products & new features, access troubleshooting guides, register sources, platforms support.

Products

Data Security Alliance

COHESITY Documentation

Explore our documentation to get started, discover products & new features, access troubleshooting guides, register sources, platforms support.

Products

Data Security Alliance

About performing a full backup after a restore — NetBackup 11.2.0.1 | Cohesity Documentation

Home

NetBackup

NetBackup™ Bare Metal Restore Administrator's Guide

Protecting clients

Backing up BMR clients

About performing a full backup after a restore

You must perform a full backup of a client immediately after you restore the client and before any incremental backups occur. If the client fails again after an incremental backup but before a full backup, then BMR may not restore the client to the last incremental backup..

You can perform a manual backup of a specific client. The policy must be set to Active and the Go into effect at attribute must not be set to a future date and time.

Feedback

Was this page helpful?

About performing complete backups

Ensuring successful backups

Feedback

Was this page helpful?