Network configuration on management interface (eth1)
You can add a new data network on the management interface (eth1).
To add a new data network on eth1
- Navigate to Settings > Network > Data Network.
- Click on the Actions button (vertical ellipsis) on the right side of Data-Network. Select Add Data Network.
- Provide the required details.
You can choose to have IPv4 or IPv6 addresses in your data network. But mixed mode of IPv4 and IPv6 configuration is not supported.
The NetBackup primary server, media server, and the storage server names can contain a maximum of 64 characters, including the domain name.
Interface
Choose eth1.
Media servers
Enter the FQDN and IP address for each media server as per the input method selected.
MSDP engines
Enter the FQDN and IP addresses for each MSDP engine as per the input method selected.
Primary server
Enter the FQDN and IP address of primary server.
Note:
If you deploy a cluster with only media servers, you do not have to enter these details.
Note:
When you select eth1 from the drop-down list, the routing details for subnet, gateway and VLAN ID values are auto populated based on the existing management network. These values cannot be modified.
The input IPs for media/MSDP engine/primary server should belong to same subnet as the existing management network.
Note:
The secondary data network to be added on the management interface must be in the same network as the existing network of the management interface. The secondary data network to be added on the management interface cannot be the same as any existing data networks (primary or secondary).
- Click Add Data Network. The process for adding the network is initiated.
- View the Recent Activity panel in the top navigation bar for the status of the task. You can monitor the status of the operation by clicking View details on the taskbar.
- Once the data network is added successfully, the newly added data network appears under Data Network.
