Replacement procedure for quad-port NIC
This topic describes the process of replacing the NIC quad port on an HPE server node.
Verify if the cables are unplugged or faulty. After removing cable from quad-port NIC node state in the UI shows Unhealthy.
The eth1 network interface state is shown unplugged in the UI. To view the link status, navigate to in the NetBackup Flex Scale infrastructure UI.
The network status for the public network is shown unhealthy. Navigate to the dashboard page of the UI:
In the iLO remote console, adapter1 slot 3 status is shown as link down.
An event notifying that the eth1 network interface is in faulted state is shown on the page of the UI:
If you encounter these issues, there might be a problem with the cables connection or the quad-port. To isolate the issue, first tighten the cable connections. If you face the same issue, replace the cables and try again. If the issue persists it implies that the port is faulty. Contact Veritas TSE to replace the faulty quad-port NIC.
Note the MAC address of the network interface. After the quad-port NIC is replaced, the MAC address will change:
Before an HPE representative can replace the quad-port NIC, you must shut down the node.
To shut down the node:
- Sign in to the NetBackup Flex Scale infrastructure management UI and navigate to Monitor > Infrastructure > Nodes.
- On the node where the failure occurred, click the Actions menu (vertical ellipsis) from the right side of the row in the UI and click Shutdown node.
The HPE representative replaces the quad-port NIC.
After the hardware vendor notifies you that the hardware component is replaced, verify that the issue is resolved.
To verify that the issue is resolved, complete the following steps:
- Restart the node from the iLO remote console using the Power > Momentary Press option.
The green color power symbol indicates that the node has started.
- As the port is changed physically, the MAC address is also changed, which results in the following cases:
The node status is shown unhealthy in the UI:
The eth1 network interface state is shown unplugged in the UI. To view the link status, navigate to Infrastructure > Hardware > Network Card in the NetBackup Flex Scale infrastructure UI.
In the iLO remote console, adapter1 slot 3 status is shown as link down:
An event notifying that the eth1 network interface is in faulted state is shown on the Settings > Events page of the UI:
- Verify that the node status is shown healthy in the UI:
- Verify that the eth1 link state has changed to Plugged:
- The public network status is shown healthy:
- Verify that Adapter 1 slot 3 link status is shown OK:
- Verify that the changed MAC ID can be seen in the system hardware-health and in ifconfig eth1 output:
